Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › EVAPORATOR TEMPERATURE SENSOR (for Rear Air Conditioning System)

EVAPORATOR TEMPERATURE SENSOR (for Rear Air Conditioning System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR A/C EVAPORATOR TEMPERATURE SENSOR
  1. Remove the rear evaporator temperature sensor.



    E112577E08
  1. Disconnect the connector from the rear evaporator temperature sensor.



  1. Measure the resistance according to the value(s) in the table below.


    I040629E06

    Standard resistance:
    Tester connection
    Condition
    Specified condition
    1 - 2
    -10°C (14°F)
    7.40 to 9.20 kΩ
    1 - 2
    -5°C (23°F)
    5.65 to 7.00 kΩ
    1 - 2
    0°C (32°F)
    4.35 to 5.40 kΩ
    1 - 2
    5°C (41°F)
    3.40 to 4.20 kΩ
    1 - 2
    10°C (50°F)
    2.68 to 3.30 kΩ
    1 - 2
    15°C (59°F)
    2.10 to 2.60 kΩ
    1 - 2
    20°C (68°F)
    1.66 to 2.10 kΩ
    1 - 2
    25°C (77°F)
    1.32 to 1.66 kΩ
    1 - 2
    30°C (86°F)
    1.05 to 1.35 kΩ

    NOTICE:
    1. Even slightly touching the sensor may change the resistance value. Be sure to hold the connector of the sensor.
    2. When measuring the sensor temperature must be the same as the ambient temperature.

    HINT:
    As the temperature increases, the resistance decreases (see the graph).

    If the resistance is not as specified, replace the rear evaporator temperature sensor.