Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › HEATER RELAY (for Rear Air Conditioning System)

HEATER RELAY (for Rear Air Conditioning System) > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT REAR HEATER RELAY
  1. Remove the rear heater relay.



    E032993
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω
    3 - 4
    Always
    Below 1 Ω
    When battery voltage is applied to terminals 1 and 2
    10 kΩ or higher

    If the resistance is not as specified, replace the rear heater relay.