Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › INTEGRATION CONTROL AND PANEL

INTEGRATION CONTROL AND PANEL > REMOVAL

for Preparation Click here



1. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.1


    B067329E01
  1. Using a moulding remover, disengage the 3 clips as shown in the illustration.

  1. Disconnect the connector and remove the instrument cluster finish panel center No. 1.



2. REMOVE INSTRUMENT CLUSTER FINISH PANEL CENTER NO.2


3. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

HINT:
(Click here for U151E, Click here for U151F)



4. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY CENTER


    B066703E01
  1. Remove the screw <C>.

  1. Disengage the 5 clips and the claw from the lowest part on the instrument cluster finish panel assembly center in order.

  1. Disconnect the connectors at the instrument cluster finish panel sub-assembly lower center, and then remove the instrument cluster finish panel assembly center.



5. REMOVE INSTRUMENT CLUSTER FINISH PANEL GARNISH


    B067325E01
  1. Insert the edge of a moulding remover between the instrument cluster finish panel garnish and the radio receiver from the top center, and then lean the moulding remover toward the front of the vehicle to raise the instrument cluster finish panel garnish.

  1. Disengage the claw on the top of the instrument cluster finish panel garnish and the two clips from the radio receiver.



    B067326
  1. Pull up the instrument cluster finish panel garnish to the front of the vehicle to disengage the 5 claws at the bottom of the instrument cluster finish panel garnish.

  1. Remove the instrument cluster finish panel garnish.



6. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Navigation System)


    E119947
  1. Remove the 4 screws.

  1. Disconnect the connectors and remove the radio receiver with bracket.



7. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/ Navigation System)


8. REMOVE INTEGRATION CONTROL AND PANEL ASSEMBLY


    I035724
  1. Remove the 4 screws, and release the integration control & panel assembly.

  1. Disconnect the connectors and remove the integration control & panel assembly.