INTEGRATION CONTROL AND PANEL > DISASSEMBLY |
| 1. REMOVE CENTER CLUSTER MODULE KNOB NO.1 (for Manual Air Conditioning System) |
![]() |
Remove the center cluster module knob No. 1.
| 2. REMOVE CENTER CLUSTER MODULE KNOB NO.2 (for Manual Air Conditioning System) |
![]() |
Release the 2 claws fittings and remove the center cluster module knob No. 2.
| 3. REMOVE AIR CONDITIONER AMPLIFIER ASSEMBLY (for Manual Air Conditioning System) |
![]() |
Remove the plate.
![]() |
Release the lock of the connector and disconnect the cable.
![]() |
Remove the 4 screws, and the heater control housing.
![]() |
Remove the 4 screws, and the air conditioner amplifier assembly.
| 4. REMOVE AIR CONDITIONER AMPLIFIER ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Release the 8 claw fittings and remove the 4 screws and the heater control housing.
![]() |
Disconnect the 2 connectors.
![]() |
Remove the 5 screws and the air conditioner amplifier assembly.
| 5. REMOVE INTEGRATION CONTROL AND PANEL BULB (for Manual Air Conditioning System) |
![]() |
Remove the integration control & panel bulb.
| 6. REMOVE HEATER BLOWER SWITCH (for Manual Air Conditioning System) |
![]() |
Remove the 3 nuts, and the 3 washers.
![]() |
Release the 6 claw fittings and remove the 5 screws and printed wire integration board sub-assembly.
![]() |
Remove the screw and the heater blower switch.
| 7. REMOVE PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY (for Automatic Air Conditioning System) |
![]() |
Remove the 12 screws and the printed wire integration board sub-assembly.
| 8. REMOVE CLOCK ORNAMENT |
![]() |
Remove the clock ornament.
| 9. REMOVE CENTER CLUSTER MODULE KNOB NO.5 (for Automatic Air Conditioning System) |
| 10. REMOVE CENTER CLUSTER MODULE KNOB NO.6 (for Automatic Air Conditioning System) |