Home › BODY › SEAT › SEAT HEATER SYSTEM

SEAT HEATER SYSTEM > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK SEAT HEATER CONTROL (WIRE HARNESS SIDE)


    B088526E01
  1. Disconnect the connector from the seat heater control.

  1. Measure the voltage and resistance of each terminal of the wire harness side connector.

    Standard:
    Tester Connection
    Condition
    Specified Condition
    1 - Body ground
    Always
    Below 1 Ω
    1 - 3
    Seat heater switch
    OFF → ON
    (Ignition switch ON)
    0 V → 11 to 14 V
    1 - 4
    Always
    11 to 14 V

    If the result is not as specified, there may be a malfunction on the wire harness side or the seat heater switch.