WINDOW DEFOGGER SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT BACK WINDOW (DEFOGGER WIRE) |
![]() |
![]() |
Turn the ignition switch ON.
Turn the defogger switch ON.
![]() |
Inspect the voltage at the center of each defogger wire, as shown in the illustration.
| Voltage | Criteria |
| Approx. 5 V | Okay, wire is not broken |
| Approx. 10 V to 0 V | Wire is broken |
Place the voltmeter positive (+) lead against the defogger wire on the battery side.
Place the voltmeter negative (-) lead with the foil strip against the wire on the ground side.
Slide the positive (+) lead from the battery side to the ground side.
The point where the voltmeter deflects from approx 10 V to 0 V is the place where the defogger wire is broken.
| 2. INSPECT WIRE HARNESS (FRONT WINDOW DEICER WIRE) |
![]() |
Inspect the resistance of the deicer wire.
| Terminal No. | Condition | Specified Condition |
| 1 - 2 | Constant | Below 1 Ω |