Home › BODY › WINDSHIELD / WINDOWGLASS › WINDOW DEFOGGER SYSTEM

WINDOW DEFOGGER SYSTEM > REPAIR

for Preparation Click here



1. REPAIR REAR WINDOW DEFOGGER WIRE


    B063722E08
  1. Clean the broken wire tips with grease, wax and silicone remover.

  1. Place the masking tape along the both sides of the wire.

  1. Thoroughly mix the repair agent (Dupont paste No. 4817).



    B063723
  1. Using a fine tip brush, apply a small amount of the agent to the wire.

  1. After a few minutes, remove the masking tape.

    NOTICE:
    Do not repair the defogger wire again for at least 24 hours.