Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL HEADLIGHT ASSEMBLY
  1. Connect the connectors.



    E119908
  1. Install the headlight assembly with the bolt and 3 screws.



2. INSTALL FRONT BUMPER ASSEMBLY


    B125282
  1. Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Connect the connectors if necessary.



    B125280
  1. Install the 5 clips.



    B125279
  1. Connect the engine under cover to the front bumper assembly with the 8 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62.0 in.*lbf }



    B125278
  1. Connect the fender liner to the front bumper assembly with the 4 screws.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. VEHICLE PREPARATION FOR HEADLIGHT AIMING


5. PREPARATION FOR HEADLIGHT AIMING (Using a tester)


6. PREPARATION FOR HEADLIGHT AIMING (Using a screen)


7. HEADLIGHT AIMING INSPECTION


8. HEADLIGHT AIMING ADJUSTMENT


9. VEHICLE PREPARATION FOR FOG LIGHT AIMING


10. PREPARATION FOR FOG LIGHT AIMING


11. FOG LIGHT AIMING INSPECTION


12. FOG LIGHT AIMING ADJUSTMENT