Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT ASSEMBLY

HEADLIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL


2. REMOVE FRONT BUMPER ASSEMBLY


    B125278
  1. Remove the 4 screws and separate the fender liner from the front bumper assembly.



    B125279
  1. Remove the 8 screws and separate the engine under cover from the front bumper assembly.



    B125280
  1. Remove the 5 clips.



    B125281
  1. Disengage the claws on the left and right sides of the front bumper and pull the front bumper toward the front of the vehicle as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Disconnect the connectors if necessary.



3. REMOVE HEADLIGHT ASSEMBLY
  1. Disconnect the connectors.



    E119908
  1. Remove the bolt, 3 screws and headlight assembly.