Home › BODY ELECTRICAL › LIGHTING › FOG LIGHT ASSEMBLY

FOG LIGHT ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL FOG LIGHT ASSEMBLY


    E119931
  1. Install the fog light assembly with the 2 claws and 2 pins.



2. INSTALL FRONT BUMPER ASSEMBLY


    B125282
  1. Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Connect the connectors if necessary.



    B125280
  1. Install the 5 clips.



    B125279
  1. Connect the engine under cover to the front bumper assembly with the 8 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62.0 in.*lbf }



    B125278
  1. Connect the fender liner to the front bumper assembly with the 4 screws.



3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL


4. VEHICLE PREPARATION FOR FOG LIGHT AIMING


5. PREPARATION FOR FOG LIGHT AIMING


6. FOG LIGHT AIMING INSPECTION


7. FOG LIGHT AIMING ADJUSTMENT