FRONT BUMPER > INSTALLATION |
| 1. INSTALL FRONT BUMPER ASSEMBLY |
![]() |
Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration.
![]() |
Install the 5 clips.
![]() |
Connect the engine under cover to the front bumper assembly with the 8 screws.
![]() |
Connect the fender liner to the front bumper assembly with the 4 screws.
| 2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL |
| 3. VEHICLE PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) |
Prepare the vehicle:
| 4. PREPARATION FOR FOG LIGHT AIMING (w/ Fog Light) |
![]() |
Prepare the vehicle according to the following conditions:
Prepare a piece of thick white paper (approximately 2 m (6.6 ft) (height) x 4 m (13.1 ft) (width)) to use as a screen.
Draw a vertical line down the center of screen (V line).
Set the screen as shown in the illustration.

![]() |
Draw base lines (H line, V LH, V RH lines) on the screen as shown in the illustration.
H Line (Fog light height):
Draw a horizontal line across the screen so that it passes through the center marks. The H line should be at the same height as the fog light bulb center marks of the low-beam fog lights.
V LH Line, V RH Line (Center mark position of left-hand (LH) and right-hand (RH) fog lights):
Draw two vertical lines so that they intersect the H line at each center mark.
| 5. FOG LIGHT AIMING INSPECTION (w/ Fog Light) |
Cover or disconnect the connector of the fog light on the opposite side to prevent light from the fog light not being inspected from affecting fog light aiming inspection.
Start the engine.
Turn on the fog light and make sure that the cutoff line falls within the specified area, as shown in the illustration.

| 6. FOG LIGHT AIMING ADJUSTMENT (w/ Fog Light) |
![]() |
Adjust the fog light aim into the specified range by turning aiming screw with a screwdriver.