Home › BODY › EXTERIOR › FRONT BUMPER

FRONT BUMPER > REASSEMBLY

for Preparation Click here



1. INSTALL LOWER RADIATOR GRILLE


    B125289
  1. Engage the 16 claws to install the lower radiator grille to the front bumper cover.



2. INSTALL FRONT BUMPER HOLE COVER LH (w/o Fog Light)


    B125288
  1. Engage the 2 pins to install the front bumper hole cover LH to the front bumper cover.



3. INSTALL FRONT BUMPER HOLE COVER RH (w/o Fog Light)

HINT:
Perform the same procedure as for the LH side.



4. INSTALL FOG LIGHT ASSEMBLY LH (w/ Fog Light)


    E119931
  1. Install the fog light assembly with the 2 claws and 2 pins.



5. INSTALL FOG LIGHT ASSEMBLY RH (w/ Fog Light)

HINT:
Perform the same procedure as for the LH side.



6. INSTALL FRONT BUMPER EMBLEM


    B125287
  1. Engage the 3 claws to install the front bumper emblem to the upper radiator grille.



7. INSTALL UPPER RADIATOR GRILLE


    B125286
  1. Engage the 10 claws to install the upper radiator grille to the radiator grille.



8. INSTALL RADIATOR GRILLE


    B125285
  1. Engage the 4 claws to install the radiator grille to the front bumper cover.

  1. Install the 2 bolts and the 2 screws.

    Torque:
    Bolt:
    5.4 N*m{ 54 kgf*cm , 48 in.*lbf }
    Screw:
    5.0 N*m{ 51 kgf*cm , 44.3 in.*lbf }



9. INSTALL NO. 1 ULTRASONIC SENSOR (LH side) (w/ Clearance Sonar System)
  1. Connect the connector and install the No. 1 ultrasonic sensor.



10. INSTALL NO. 1 ULTRASONIC SENSOR (RH side) (w/ Clearance Sonar System)

HINT:
Perform the same procedure as for the LH side.



11. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER
  1. Install the No. 1 ultrasonic sensor retainer.



12. INSTALL FRONT BUMPER SIDE SUPPORT LH


    B125283
  1. Engage the 2 clips to install the front bumper side support LH.

  1. Install the screw.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62.0 in.*lbf }



13. INSTALL FRONT BUMPER SIDE SUPPORT RH

HINT:
Perform the same procedure as for the LH side.



14. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B125284
  1. Install the front bumper reinforcement sub-assembly with the 6 bolts.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }



15. INSTALL FRONT BUMPER ENERGY ABSORBER