Home › BODY ELECTRICAL › METER › METER / GAUGE SYSTEM

METER / GAUGE SYSTEM > Meter Illumination is Always Dark

for Preparation Click here


DESCRIPTION

  1. Confirm that the vehicle is equipped with the optitron meter, then check this circuit.
  1. The combination meter assembly receives a auto dimmer signal from the body ECU by the multiplex communication line.

WIRING DIAGRAM


E118069E04


INSPECTION PROCEDURE

1.CHECK MULTIPLEX COMMUNICATION SYSTEM
  1. Check if MULTIPLEX communication DTC is output (Click here).

    Result:

    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



NG
REPLACE CIRCUITS INDICATED BY OUTPUT DTCS
OK


2.CHECK DTC
  1. Check if DTC B1244 is output (Click here).

    Result:

    Result
    Proceed to
    B1244 is not output
    A
    B1244 is output
    B



B
GO TO LIGHTING SYSTEM
A


3.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Operate Techstream according to the steps on the display and select "Data List".

    Main Body: 
    Item
    Test Details
    Diagnostic Note
    Dimmer Signal
    Auto dimmer signal ON/OFF
    OFF: Auto dimmer is OFF
    ON: Auto dimmer is ON

    OK:
    The meter illumination is dimmed when the DIMMER SIG is ON.



NG
Go to step 4
OK

CHECK LIGHTING SETTING 

4.REPLACE COMBINATION METER ASSEMBLY

OK:
The operation of the combination meter assembly returns to normal.



NG
REPLACE BODY ECU
OK

END