Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING (for 2WD)

REAR AXLE HUB AND BEARING (for 2WD) > REMOVAL

for Preparation Click here


HINT:
Replace the RH side by the same procedures as the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Removing the 2 bolts, separate the rear disc brake caliper assembly LH for disc rear brake type.

    NOTICE:
    Using a string and so on, hang down the disc brake caliper.



3. REMOVE REAR DISC
  1. Remove the rear disc for disc rear brake type.



4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY
  1. Remove the rear brake drum sub-assembly for drum rear brake type.



5. SEPARATE SKID CONTROL SENSOR WIRE
  1. Disconnect the connector.



6. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH


    C066210E04
  1. Remove the 4 nuts and hub & bearing assembly LH.