Home › SUSPENSION & AXLE › AXLE › REAR AXLE HUB AND BEARING (for 4WD)

REAR AXLE HUB AND BEARING (for 4WD) > REMOVAL

for Preparation Click here


HINT:
Replace the RH side by the same procedures as the LH side.



1. REMOVE REAR WHEEL


2. REMOVE REAR AXLE SHAFT LH NUT


    F045049E02
  1. Using SST and a hammer, unstake part of the axle shaft nut.

    SST
    09930-00010  

    NOTICE:
    Loosen the staked part of the nut completely, otherwise the screw of the drive shaft may be damaged.

  1. While apply the brakes, remove the axle shaft nut.



3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
  1. Removing the 2 bolts, separate the rear disc brake caliper assembly LH.



4. REMOVE REAR DISC


5. SEPARATE SPEED SENSOR REAR LH
  1. Removing the bolt, separate the speed sensor rear LH.

    NOTICE:
    1. Be careful not to damage the speed sensor.
    2. Prevent foreign matter from attaching to the speed sensor.



6. REMOVE REAR DRIVE SHAFT ASSEMBLY LH


    C097746E01
  1. Place matchmarks on the drive shaft and differential side gear shaft.

  1. Remove the 4 nuts and washers, and disconnect the drive shaft from the differential side gear shaft.

  1. Remove the drive shaft from the axle carrier.



7. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH


    C065991E01
  1. Remove the 4 nuts and hub & bearing assembly LH.