Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Headlight Relay Circuit

for Preparation Click here


DESCRIPTION

The Multiplex network body ECU controls HEAD relay when signal is received from headlight dimmer switch assembly.

WIRING DIAGRAM


E142645E01


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Body / Active Test.

  1. Check the operation.

    Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Headlight Relay
    Headlight relay
    ON/OFF
    -



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT HEADLIGHT RELAY


    E064835E10
  1. Inspect headlight relay continuity.

    Resistance:
    Condition
    Tester Connection
    Specified Condition
    Always
    3 - 5
    10 kΩ or higher
    Apply B+ between the terminal 1 and 2
    3 - 5
    Below 1 Ω



NG
REPLACE HEADLIGHT RELAY
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Measure voltage between the terminal as shown in the chart below.

    Voltage:

    Tester Connection
    Condition
    Specified Voltage (V)
    1C-10 - Body ground
    Light control switch OFF → ON
    Below 1 V → 10 to 14 V


    E067348E03



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR