Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Front Fog Light Circuit

for Preparation Click here


DESCRIPTION

The Multiplex network body ECU controls FOG relay when signal is received from headlight dimmer switch assembly.

WIRING DIAGRAM


E142646E02


INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Body / Active Test.

  1. Check the operation.

    Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Front Fog Light Relay
    Front fog light relay
    ON/OFF
    -

    OK:
    Front fog lights come on.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT FOG LIGHT RELAY


    B016200
  1. Inspect fog light relay continuity.

    Standard:
    Condition
    Tester Connection
    Specified Condition
    Always
    3 - 5
    10 kΩ or higher
    Apply B+ between the terminal 1 and 2
    3 - 5
    Below 1 Ω



NG
REPLACE FOG LIGHT RELAY
OK


3.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Measure voltage between the terminal B8-7 of the multiplex network body ECU in the instrument panel junction block assembly and body ground.


    E067349E05


    Voltage:

    Tester Connection (Symbols)
    Condition
    Specified Condition
    B8-7 - Body ground
    Light control switch TAIL and Fog light switch ON
    Below 1 V
    B8-7 - Body ground
    Light control switch TAIL and Fog light switch ON
    10 to 14 V



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK


4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


  1. Remove the instrument panel junction block assembly.


    E067348E05



  1. Measure voltage between each of the terminals as shown in the chart below.


    E067349E06


    Voltage:

    Tester Connection (Symbols)
    Condition
    Specified Condition
    1C-1 - Body ground
    Light control switch TAIL and Fog light switch OFF
    Below 1 V → 10 to 14 V
    1C-12 - Body ground
    Light control switch TAIL and Fog light switch OFF
    Below 1 V → 10 to 14 V
    1H-28 - Body ground
    Light control switch TAIL and Fog light switch OFF
    10 to 14 V → Below 1 V



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR