Home › BODY ELECTRICAL › LIGHTING › LIGHTING SYSTEM

LIGHTING SYSTEM > Parking Brake Switch Circuit

for Preparation Click here


DESCRIPTION

The Multiplex network body ECU receives parking brake switch signal.

WIRING DIAGRAM


E068124E02


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Body / Data List.

  1. Read the display on the Techstream.

    Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Parking Brake SW
    Parking brake SW signal / ON or OFF
    ON: Parking brake switch is ON
    OFF: Parking brake switch is OFF
    -

    OK:
    Normal conditions listed above are displayed.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT PARKING BRAKE SWITCH ASSEMBLY
  1. Check that there is resistance between the terminal and the body ground when parking brake switch is operated.

    Resistance:
    ON (When shaft is pressed): No continuity:
    10 kΩ or higher
    OFF (When shaft is not pressed): Continuity:
    Below 1 Ω



NG
REPLACE PARKING BRAKE SWITCH ASSEMBLY
OK


3.CHECK HARNESS AND CONNECTOR


  1. Disconnect the 1K connector from instrument panel junction block assembly.


    E067348E09

  1. Check the resistance between the terminal 1K-10 of the instrument panel junction block assembly connector side and body ground.



Tester Connection
Condition
Specified Condition
1K-10 - Body ground
Shaft of parking brake switch is pressed
10 kΩ or higher
1K-10 - Body ground
Shaft of parking brake switch is not pressed
Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE