Home › BODY ELECTRICAL › LIGHTING › HEADLIGHT DIMMER SWITCH

HEADLIGHT DIMMER SWITCH > INSPECTION

for Preparation Click here



1. HEADLIGHT DIMMER SWITCH ASSEMBLY


    E057951
  1. Inspect light control switch resistance.

    1. Check that there is resistance between the terminals at each switch position as shown in the chart.

      Resistance:
      Switch operation
      Tester connection
      Specified condition
      OFF
      -
      10 kΩ or higher
      TAIL
      14 - 16
      Below 1 Ω
      HEAD
      13 - 16 - 14
      Below 1 Ω
      AUTO
      12 - 16
      Below 1 Ω

  1. Inspect light control switch resistance.

    1. Check that there is resistance between the terminals at each switch position as shown in the chart.

      Resistance:
      Switch operation
      Tester connection
      Specified condition
      FLASH
      7 - 8 - 16
      Below 1 Ω
      LOW BEAM
      16 - 17
      Below 1 Ω
      HI BEAM
      7 - 16
      Below 1 Ω

  1. Inspect light control switch resistance.

    1. Check that there is resistance between the terminals at each switch position as shown in the chart.

      Resistance:
      Switch operation
      Tester connection
      Specified condition
      Right turn
      2 - 3
      Below 1 Ω
      Neutral
      -
      10 kΩ or higher
      Left turn
      1 - 2
      Below 1 Ω

  1. Inspect light control switch resistance.

    1. Check that there is resistance between the terminals at each switch position as shown in the chart.

      Resistance:
      Switch operation
      Tester connection
      Specified condition
      OFF
      -
      10 kΩ or higher
      ON
      11 - 18
      Below 1 Ω