Home › BODY ELECTRICAL › LIGHTING › TURN SIGNAL LIGHT SWITCH

TURN SIGNAL LIGHT SWITCH > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TURN SIGNAL FLASHER CIRCUIT


    E015683E04
  1. Measure voltage between the terminals as shown in the chart below.

    Voltage:

    Tester connection
    Condition
    Specified condition
    1 - body ground
    Turn ignition switch ON
    10 to 14 V
    1 - body ground
    Turn ignition switch OFF
    No voltage
    4 - body ground
    Always
    10 to 14 V
    7 - body ground
    Always
    Continuity

  1. Connect the connector to turn the signal flasher and turn the ignition switch ON, and inspect the wire harness side connector from the back side as shown in the chart.

    Voltage:

    Tester connection
    Condition
    Specified condition
    2 - body ground
    Hazard switch OFF → ON
    0V → 10 to 14 V (60 to 120 time per minutes)
    2 - body ground
    Turn signal switch (right turn) OFF → ON
    0V → 10 to 14 V (60 to 120 time per minutes)
    3 - body ground
    Hazard switch OFF → ON
    0V → 10 to 14 V (60 to 120 time per minutes)
    3 - body ground
    Turn signal switch (left turn) OFF → ON
    0V → 10 to 14 V (60 to 120 time per minutes)
    5 - body ground
    Turn signal switch (left turn) OFF → ON
    10 to 14 V → 0V
    6 - body ground
    Turn signal switch (right turn) OFF → ON
    10 to 14 V → 0V
    8 - body ground Hazard
    Hazard switch OFF → ON
    10 to 14 V → 0V