Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    C1225/25    SM Solenoid Circuit

for Preparation Click here


DESCRIPTION

This solenoid turns on when receiving signals the ECU and controls the pressure acting on the wheel cylinders to control the braking force.

DTC Code
DTC Detection Condition
Trouble Area
C1225/25
When any of the following is detected:
  1. When SM1 or SM2 is ON, excessive electric current on SM1 or SM2 continues for 0.05 seconds or more.
  2. When SM1 or SM2 is OFF, open circuit of SM1 or SM2 continues for 0.05 seconds or more.
  3. When SM1 or SM2 is ON, open circuit of SM1 or SM2 continues for 0.1 seconds or more.
  4. When SM1 or SM2 is OFF, electric current application on SM1 or SM2 continues for 0.1 seconds or more.
  5. Short to GND in the switching solenoid (SM1 or SM2) continues for 0.1 sec. or more.
  6. Switching solenoids (SM1 and SM2) are shorted for 0.1 sec. or more.
  1. Brake actuator assembly
  2. VSC solenoid circuit

WIRING DIAGRAM

Refer to DTCs C0226/21, C0236/22, C0246/23 and C0256/24 .

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to the ON position.

  1. Are the same DTCs recorded?

    Result:

    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B

    NOTICE:
    When replacing brake actuator assembly, perform zero point calibration (Click here).



B
END
A

REPLACE BRAKE ACTUATOR ASSEMBLY