Home › BODY ELECTRICAL › NAVIGATION › NAVIGATION SYSTEM

DTC    5C-40    Camera Picture Error

for Preparation Click here


DESCRIPTION


DTC No.
DTC Detection Condition
Trouble Area
5C-40
Synchronous signal from the camera cannot be transmitted.
  1. Wire harness
  2. Television camera assembly
  3. Navigation receiver assembly

WIRING DIAGRAM


E121277E02


INSPECTION PROCEDURE

HINT:
After the inspection is completed, clear the DTCs.

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ASSEMBLY)
  1. Disconnect the R10 connector from the navigation receiver assembly.



  1. Disconnect the T10 connector from the television camera assembly.


    E121278E05

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:

    Tester Connection (Terminal No.)
    Condition
    Specified Condition
    CB+ (T10-4) - CA+ (R10-24)
    Always
    Below 1 Ω
    CGND (T10-3) - CGND (R10-21)
    Always
    Below 1 Ω
    CV+ (T10-2) - V+ (R10-22)
    Always
    Below 1 Ω
    CV- (T10-1) - V- (R10-23)
    Always
    Below 1 Ω
    CV- (T10-1) - Body ground
    Always
    10 kΩ or higher
    CV+ (T10-2) - Body ground
    Always
    10 kΩ or higher
    CGND (T10-3) - Body ground
    Always
    10 kΩ or higher
    CB+ (T10-4) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


  1. Reconnect the navigation receiver assembly connector.


    E121279E04

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:

    Tester Connection (Terminal No.)
    Condition
    Specified Condition
    CB+ (T10-4) - CGND (T10-3)
    IG SW ON, shift lever R position
    Approx. 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


3.INSPECT TELEVISION CAMERA ASSEMBLY


  1. Reconnect the navigation receiver assembly R10 connector and the television camera assembly T10 connector.


    E121280E02



    E119731E02
  1. Check the waveform of the television camera assembly using an oscilloscope.

    1. Measurement terminal: CV+ - CV-
      Measurement setting: 0.2 V/DIV, 0.2 μs/DIV
      Condition: Ignition switch ON, Shift lever in R range

      OK:
      Pulses as shown in the illustration.



NG
REPLACE TELEVISION CAMERA ASSEMBLY
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY