Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Park / Neutral Position Switch Circuit

for Preparation Click here


DESCRIPTION

The clearance warning ECU receives the reverse or park position signal from the park / neutral position switch.

WIRING DIAGRAM


E124036E01


INSPECTION PROCEDURE

1.INSPECT CLEARANCE WARNING ECU


    E124033E01
  1. Disconnect the C9 connector from the clearance warning ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    RL - Body ground
    Ignition switch ON, shift lever in R position
    10 to 14 V
    PL - Body ground
    Ignition switch ON, shift lever in P position
    10 to 14 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.CHECK HARNESS AND CONNECTOR


    E124035E01
  1. Disconnect the connector from the park / neutral position switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    RL - P1-1
    Always
    Below 1 Ω
    PL - P1-6
    Always
    Below 1 Ω
    RL - Body ground
    Always
    10 kΩ or higher
    PL - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT PARK / NEUTRAL POSITION SWITCH


    E110857E02
  1. Disconnect the park / neutral position switch connector P1.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    P1-1 - P1-2
    Shift lever is in R position.
    Below 1 Ω
    P1-1 - P1-2
    Shift lever is in any position except R.
    10 kΩ or higher
    P1-2 - P1-6
    Shift lever is in P position.
    Below 1 Ω
    P1-2 - P1-6
    Shift lever is in any position except P.
    10 kΩ or higher



NG
REPLACE PARK / NEUTRAL POSITION SWITCH
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR