Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Clearance Warning ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit provides power to the clearance warning ECU.

WIRING DIAGRAM


E124039E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - AIR CONDITIONER AMPLIFIER)


    E145205E04
  1. Disconnect the connectors from the clearance warning ECU C9 and air conditioner amplifier connector A10 or A11.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    +B - SK
    Always
    Below 1 Ω
    +B - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - BODY GROUND)


    E124033E10
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT CLEARANCE WARNING ECU


    E124033E11
  1. Disconnect the clearance warning ECU connector.

  1. Turn the ignition switch ON.

  1. Turn the clearance sonar main switch ON.

  1. Measure the voltage between terminals +B and E of the ECU.

    Standard voltage:
    10 to 14 V

    Result:
    Result
    Proceed to
    OK
    A
    NG
    B (Auto A/C)
    NG
    C (Manual A/C)



B
Go to step 4

C
Go to step 5
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

4.INSPECT PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY
  1. Check that the malfunction disappears when a known good printed wire integration board sub-assembly is installed.

    OK:
    Malfunction disappears.



NG
REPLACE AIR CONDITIONER AMPLIFIER
OK

REPLACE PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY 

5.INSPECT INTEGRATION PANEL SUB-ASSEMBLY
  1. Check that the malfunction disappears when a known good integration panel sub-assembly is installed.

    OK:
    Malfunction disappears.



NG
REPLACE AIR CONDITIONER AMPLIFIER
OK

REPLACE INTEGRATION PANEL SUB-ASSEMBLY