Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > No. 1 Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning ECU receives the ultrasonic sensor signal to sound the front warning buzzer.

WIRING DIAGRAM


E124043E01


INSPECTION PROCEDURE

1.INSPECT FRONT BUZZER


    E145204E01
  1. Remove the clearance warning ECU with front buzzer.

  1. Apply the battery voltage to the terminals 1 and 2 of the buzzer, and check that the buzzer sounds.

    HINT:
    The clearance warning buzzer is separately excited, and will not sound unless an alternating voltage is applied.

    OK:
    Operating noise (clicking sounds) can be heard.



NG
REPLACE FRONT BUZZER
OK


2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - FRONT BUZZER)


    E124045E01
  1. Disconnect the clearance warning ECU connector and front buzzer connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    C8-2 - CBZ
    Always
    Below 1 Ω
    CBZ - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE