Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > No. 2 Clearance Warning Buzzer Circuit

for Preparation Click here


DESCRIPTION

The clearance warning ECU receives the ultrasonic sensor signal to sound the rear warning buzzer.

WIRING DIAGRAM


E124041E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - AIR CONDITIONER AMPLIFIER)


    E145205E05
  1. Disconnect the connectors from the clearance warning ECU C9 and air conditioner amplifier connector A10 or A11.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    BBZ - Z-
    Always
    Below 1 Ω
    BBZ - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT REAR BUZZER


    E145206E03
  1. Remove the integration control & panel assembly with the connectors still connected.

  1. Using a service wire, ground the terminal Z- of the integration control & panel assembly connector.

  1. Turn the ignition switch ON.

  1. Check that the rear buzzer sounds.

    HINT:
    The clearance warning buzzer is separately excited, and will not sound unless an alternating voltage is applied.

    OK:
    Operating noise (clicking sounds) can be heard.

    Result:
    Result
    Proceed to
    OK
    A
    NG
    B (Auto A/C)
    NG
    C (Manual A/C)



B
Go to step 3

C
Go to step 4
A

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

3.INSPECT PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY
  1. Check that the malfunction disappears when a known good printed wire integration board sub-assembly is installed.

    OK:
    Malfunction disappears.



NG
REPLACE AIR CONDITIONER AMPLIFIER
OK

REPLACE PRINTED WIRE INTEGRATION BOARD SUB-ASSEMBLY 

4.INSPECT INTEGRATION PANEL SUB-ASSEMBLY
  1. Check that the malfunction disappears when a known good integration panel sub-assembly is installed.

    OK:
    Malfunction disappears.



NG
REPLACE AIR CONDITIONER AMPLIFIER
OK

REPLACE INTEGRATION PANEL SUB-ASSEMBLY