Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › LASER SENSOR

LASER SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL LASER SENSOR

NOTICE:
Do not install the laser sensor if it has been damaged or received some sort of shock.



2. INSTALL FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


    B125282
  1. Push the front bumper onto the front of the vehicle and engage the claws on the left and right sides of the front bumper to install it as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Connect the connectors if necessary.



    B125280
  1. Install the 5 clips.



    B125279
  1. Connect the engine under cover to the front bumper assembly with the 8 screws.

    Torque:
    7.0 N*m{ 71 kgf*cm , 62.0 in.*lbf }



    B125278
  1. Connect the fender liner to the front bumper assembly with the 4 screws.