Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › LASER SENSOR

LASER SENSOR > REMOVAL

for Preparation Click here



1. REMOVE FRONT FENDER LINER LH


2. REMOVE FRONT FENDER LINER RH


3. REMOVE FRONT BUMPER COVER


    B125278
  1. Remove the 4 screws and separate the fender liner from the front bumper assembly.



    B125279
  1. Remove the 8 screws and separate the engine under cover from the front bumper assembly.



    B125280
  1. Remove the 5 clips.



    B125281
  1. Disengage the claws on the left and right sides of the front bumper and pull the front bumper toward the front of the vehicle as shown in the illustration.

    HINT:
    1. Apply protective tape to the bottom part of the front fender to prevent it from being damaged.
    2. Disconnect the connectors if necessary.



4. REMOVE FRONT BUMPER ENERGY ABSORBER


5. REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY


6. REMOVE LASER SENSOR


    B067364
  1. Disconnect the connector and remove the laser the sensor.