Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > INSTALLATION

for Preparation Click here



1. INSTALL HORN BUTTON ASSEMBLY


    H042675
  1. Support the steering pad with one hand as shown in the illustration.

  1. Connect the 2 connectors to the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Connect the horn connector.

  1. Confirm that the circumference groove of the "torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.

  1. Using a "torx" socket wrench (T30), tighten the 2 "torx" screws.

    Torque:
    8.8 N*m{ 90 kgf*cm , 78 in.*lbf }



2. INSTALL STEERING WHEEL COVER LOWER NO.3
  1. Install the steering wheel No.3 cover lower.



3. INSTALL STEERING WHEEL COVER LOWER NO.2
  1. Install the steering wheel No.2 cover lower.



4. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).