Home › CRUISE CONTROL SYSTEM › CRUISE CONTROL › CRUISE CONTROL MAIN SWITCH

CRUISE CONTROL MAIN SWITCH > REMOVAL

for Preparation Click here



1. DISCONNECT BATTERY NEGATIVE TERMINAL


2. REMOVE STEERING WHEEL COVER LOWER NO.2
  1. Using a screwdriver, remove the steering wheel No.2 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



3. REMOVE STEERING WHEEL COVER LOWER NO.3
  1. Using a screwdriver, remove the steering wheel No.3 cover lower.

    HINT:
    Tape up the screwdriver tip before use.



4. REMOVE HORN BUTTON ASSEMBLY


    H042695E01
  1. Using a "torx" socket wrench (T30), loosen the 2 "torx" screws until the groove along the screw circumference catches on the screw case.



    H042674
  1. Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.



5. REMOVE CRUISE CONTROL MAIN SWITCH


    E062033
  1. Disconnect the connectors.



    E062034
  1. Remove the 2 screws and cruise control main switch.