Home › ENGINE › 2GR-FE FUEL › FUEL PUMP

FUEL PUMP > INSTALLATION

for Preparation Click here



1. INSTALL FUEL TANK ASSEMBLY
  1. Set up the fuel tank assembly to the transmission jack.

  1. While operating the transmission jack, fasten the 4 claws for the wire harness and connect the fuel pump connector, then install the fuel tank and the 3 fuel tank bands to the vehicle.

  1. Tighten the 6 set bolts of the 3 fuel tank bands.

    Torque:
    33 N*m{ 336 kgf*cm , 24 ft.*lbf }

  1. Install the 2 wire harness clamps.



    A081610E01
  1. Connect the fuel tube.

    1. Push in the fuel tube connector to the pipe until fuel tube connector makes "click" sound.

      NOTICE:
      1. Check if there is any damage or foreign objects on the connected part.
      2. After connecting, check if the connector and the pipe are securely connected by pulling on them.



  1. Connect the fuel tank to filler pipe hose as shown in the illustration.


    A127590E02



    A081611E01
  1. Connect the fuel tank main tube.

    1. Push in the fuel tube connector to the pipe until fuel tube connector makes "click" sound.

      NOTICE:
      1. Check if there is any damage or foreign objects on the connected part.
      2. After connecting, check if the connector and the pipe are securely connected by pulling on them.

  1. Connect the fuel tank vent hose.



2. INSPECT FOR FUEL LEAK
  1. Check fuel pump operation.

    1. Connect the Techstream to the DLC3.

    2. Turn the ignition switch to ON.

      NOTICE:
      Do not start the engine.

    3. Turn the Techstream main switch on.

    4. Select the following menu items: Power train / Engine and ECT / Active Test / Control the Fuel Pump Speed.

    5. Check for pressure in the fuel inlet tube from the fuel line. Check that sound of fuel flowing in the fuel tank can be heard. If no sound can be heard, check the integration relay, fuel pump, ECM and wiring connector.

  1. Inspect for fuel leaks (*1).

    1. Check that there are no fuel leaks anywhere on the system after performing maintenance. If there is a fuel leak, repair or replace parts as necessary.

  1. Turn the ignition switch off.

  1. Disconnect the Techstream from the DLC3.



3. INSTALL FUEL TANK FILLER HOSE COVER


A081606E01
  1. Install the 3 bolts and the fuel tank filler hose cover.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }



4. INSTALL REAR FLOOR NO. 2 CROSSMEMBER BRACE LH


A162433
  1. Install the rear floor No. 2 crossmember brace LH with 2 bolts.

    Torque:
    28 N*m{ 286 kgf*cm , 21 ft.*lbf }



5. INSTALL CHARCOAL CANISTER PROTECTOR
  1. Install the 6bots and the charcoal canister protector.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }