FUEL PUMP > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
| 2. REMOVE CHARCOAL CANISTER PROTECTOR |
Remove the 6bolts and the charcoal canister protector.
| 3. REMOVE REAR FLOOR NO. 2 CROSSMEMBER BRACE LH |
![]() |
Remove the 2 bolts and the rear floor No. 2 crossmember brace LH.
| 4. REMOVE FUEL TANK FILLER HOSE COVER |
![]() |
Remove the 3 bolts and the fuel tank filler hose cover.
| 5. REMOVE FUEL TANK ASSEMBLY |
![]() |
Disconnect the fuel tank vent hose.
Deeply push the connector to release the locking tab.
Pinch portion A.
Pull out the connector.
![]() |
Disconnect the fuel tank main tube sub-assembly.
Pinch the tube connector and then pull out the fuel tank main tube sub-assembly.
![]() |
![]() |
Disconnect the fuel tank to filler pipe hose.
Loosen the hose clamp bolt and disconnect the fuel tank to filler pipe hose.
![]() |
Disconnect the fuel tube.
Pinch the tube connector and then pull out the fuel tank main tube sub-assembly.
![]() |
Remove the 2 wire harness clamps.
![]() |
Set up a transmission jack under the fuel tank assembly.
Remove the 6 set bolts of the 3 fuel tank bands.
![]() |
While operating the transmission jack, unfasten the 4 claws for the wire harness and disconnect the fuel pump connector, then remove the fuel tank and the 3 fuel tank bands from the vehicle.