Home › ENGINE › 2GR-FE FUEL › FUEL PUMP

FUEL PUMP > DISASSEMBLY

for Preparation Click here



1. REMOVE FUEL TANK TO FILLER PIPE HOSE


A081607E01
  1. Loosen the hose clamp bolt and remove the fuel tank to filler pipe hose from the fuel tank.



2. REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY


A164998E01
  1. Remove the tube joint clip, and pull out the fuel main tube.

    NOTICE:
    1. Check if there is any dirt or mud around the connector before this operation and remove the dirt as necessary
    2. Be careful of mud because the quick connector has an O-ring which seals the pipe and connector that can be contaminated.
    3. Do not use any tool in this operation.
    4. Do not bend or twist the nylon tube. Protect the connector by covering it with a vinyl or plastic bag.
    5. When the pipe and connector are stuck, push and pull the connector to release and pull the connector out carefully.



    A164999
  1. Unfasten the 4 claws and remove the fuel tank main tube from the fuel tank.



3. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE


A165000E01
  1. Using SST, loosen the fuel pump gauge retainer.

    SST
    09808-14020   (09808-01410, 09808-01420, 09808-01430)

    HINT:
    A rib on the fuel pump gauge retainer can be fitted into a tip of SST.

  1. Remove the fuel pump gauge retainer.

  1. Remove the fuel suction tube assembly with pump and gauge and the fuel suction tube set gasket from the fuel tank.

    NOTICE:
    Be careful not bend the arm of the fuel sender gauge.



4. REMOVE FUEL SENDER GAUGE ASSEMBLY


A079768E05
  1. Disconnect the fuel sender gauge connector.

  1. Unlock the fuel sender gauge and slide it to remove.



5. REMOVE FUEL SUCTION PLATE SUB-ASSEMBLY


A079769E01
  1. Using a screwdriver with the tip wrapped in tape, disconnect the 4 snap-claws from the claw holes and remove the fuel suction plate.

    NOTICE:
    Do not damage the fuel suction plate and the No. 1 fuel suction support.



6. REMOVE FUEL PUMP


A079770E01
  1. Disconnect the fuel pump connector.

  1. Using a small screwdriver with the tip wrapped in tape, disconnect the 2 claws from the claw holes and pull out the fuel pump.

    NOTICE:
    Do not damage the fuel pump and the fuel suction plate.

  1. Remove the O-ring and the fuel pump spacer from the fuel pump.



7. REMOVE FUEL FILTER ASSEMBLY


A079771E01
  1. Using a small screwdriver, pry out the clip.

  1. Remove the fuel filter assembly from the fuel pump.



8. REMOVE NO. 1 FUEL TUBE JOINT


A079772E01
  1. Remove the connector.

  1. Using a screwdriver with the tip wrapped in tape, disconnect the snap-claw from the claw hole and pull out the No. 1 fuel tube joint.

    NOTICE:
    Do not damage the No. 1 fuel tube joint and the fuel suction plate.



9. REMOVE FUEL PUMP HARNESS


A079773E01
  1. Remove the fuel pump harness from the No. 1 fuel tube joint.



10. REMOVE FUEL PRESSURE REGULATOR ASSEMBLY


A079774E04
  1. Remove the clip.

  1. Pull out the fuel pressure regulator from the fuel suction plate.

  1. Remove the 2 O-rings from the fuel pressure regulator.