Home › RESTRAINTS › SEAT BELT › FRONT SEAT INNER BELT ASSEMBLY

FRONT SEAT INNER BELT ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT FRONT SEAT INNER BELT ASSEMBLY RH


    B069475E01
  1. Release the seat belt (Buckle switch is ON).

  1. Check the resistance between the terminals.

    Standard:
    Terminal No.
    Specified Condition
    1 - 2
    Below 1 Ω

    If the result is not as specified, replace the inner belt assembly.



  1. Inspect the buckle switch.



      B069475E01
    1. Fasten the seat belt (Buckle switch is OFF).

    2. Check the resistance between the terminals.

      Standard:
      Terminal No.
      Specified Condition
      1 - 2
      10 kΩor higher



    B068661E01
  1. Inspect the circuit for the airbag seat position sensor.

    1. Check the resistance between the terminals.

      Standard:
      Terminal No.
      Specified Condition
      1 - 2
      (Connector for airbag seat position sensor)
      Below 1 Ω

      If the result is not as specified, replace the seat cushion assembly.



2. INSPECT FRONT SEAT INNER BELT ASSEMBLY LH


    B069476E01
  1. Inspect the buckle switch.

    1. Fasten the seat belt (Buckle switch is ON).

    2. Check the resistance between the terminals.

      Standard:
      Terminal No.
      Specified Condition
      1 - 2
      330 Ω



    B069476E01
  1. Release the seat belt (Buckle switch is OFF).

  1. Check the resistance between the terminals.

    Standard:
    Terminal No.
    Specified Condition
    1 - 2
    1,330 Ω

    If the result is not as specified, replace the inner belt assembly.