Home › DRIVE LINE › MF2A TRANSFER › TRANSFER OIL

TRANSFER OIL > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT TRANSFER OIL


    C083746E06
  1. Remove the No. 1 plug and gasket.

  1. Check the oil level is within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for No. 1 plug.

    NOTICE:
    1. When changing oil, recheck the oil level after driving.
    2. Excessively large or small quantity of oil may cause some trouble.

  1. When the oil level is too low, check for oil leakage.

  1. Tighten the No. 1 plug with a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



2. ADD TRANSFER OIL
  1. Remove the No. 1 plug and gasket and supply oil.

    NOTICE:
    1. When supplying oil, pour it slowly.
    2. Supply oil several times at several minutes interval.

    HINT:
    The oil level should be within 0 - 5 mm (0 - 0.20 in.) below the lowest end of the hole for the No. 1 plug.

  1. After leaving it alone for 5 minutes, recheck the oil level.

  1. Tighten the No. 5 plug with a new gasket.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }