Home › BODY ELECTRICAL › LIGHTING › ROOM LIGHT ASSEMBLY

ROOM LIGHT ASSEMBLY > ON-VEHICLE INSPECTION

for Preparation Click here



1. ROOM LIGHT ASSEMBLY NO.2
  1. Check that the resistance exists between the terminals.

    Resistance:
    Below 1 Ω



2. INTERIOR DOME LIGHT SWITCH ASSEMBLY
  1. Check that there is resistance between the terminals at each switch position as shown in the chart.

    Resistance:
    Switch operation
    Tester connection
    Specified condition
    OFF
    8 - 7
    9 - 7
    10 - 7
    10 kΩ or higher
    DOOR
    5 - 10
    6 - 9
    7 - 8
    Below 1 Ω
    ON
    7 - 8 - 9 - 10
    Below 1 Ω

  1. Inspect illumination operation.

    1. Connect the battery positive (+) lead to the terminal 4 and the battery negative (-) lead to the terminal 1, and check that the illumination comes on.