Home › BODY ELECTRICAL › LIGHTING › LICENSE PLATE LIGHT ASSEMBLY

LICENSE PLATE LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR GARNISH CENTER


    B069688E01
  1. Using a clip remover, disengage the 5 clips and remove the garnish center.



2. REMOVE BACK DOOR SIDE GARNISH LH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



3. REMOVE BACK DOOR SIDE GARNISH RH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



4. REMOVE BACK DOOR STRAP COVER


5. REMOVE BACK DOOR PULL STRAP


    B067784E01
  1. Using a screwdriver, disengage the claws and remove the strap cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and strap.



6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B067783E01
  1. Using the screwdriver, disengage the 14 clips and remove the trim board.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the service hole cover from the trim board.



7. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
  1. Disconnect the licence light connector.



  1. Remove the 5 nuts, clip and back door outside garnish sub-assembly.


    B067628



    B067629
  1. Remove the 2 screws and back door outside opener switch.



8. REMOVE LICENSE PLATE LIGHT ASSEMBLY


    I035546E01
  1. Release the 2 claw fittings and disconnect the license plate light assembly.

  1. Disconnect the connector and remove the license plate light assembly.