Home › BODY ELECTRICAL › LIGHTING › BACK-UP LIGHT ASSEMBLY

BACK-UP LIGHT ASSEMBLY > REMOVAL

for Preparation Click here



1. REMOVE BACK DOOR GARNISH CENTER


    B069688E01
  1. Using a clip remover, disengage the 5 clips and remove the garnish center.



2. REMOVE BACK DOOR SIDE GARNISH LH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



3. REMOVE BACK DOOR SIDE GARNISH RH
  1. Using a clip remover, disengage the 3 clips and remove the side garnish.



4. REMOVE BACK DOOR STRAP COVER SUB-ASSEMBLY


5. REMOVE BACK DOOR PULL STRAP


    B067784E01
  1. Using a screwdriver, disengage the claws and remove the strap cover.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the bolt and strap.



6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY


    B067783E01
  1. Using the screwdriver, disengage the 14 clips and remove the trim board.

    HINT:
    Tape the screwdriver tip before use.

  1. Remove the service hole cover from the trim board.



7. REMOVE BACK-UP LIGHT ASSEMBLY


    I035545E03
  1. Disconnect the connector.

  1. Release the 2 claw fittings and remove the 4 nuts and the back-up light assembly.