Home › SUSPENSION & AXLE › SUSPENSION › REAR WHEEL ALIGNMENT

REAR WHEEL ALIGNMENT > ADJUSTMENT

for Preparation Click here


NOTICE:
For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally:
  1. Disconnect the negative battery terminal for more than 2 seconds.
  2. Reconnect the negative battery terminal.
  3. Perform zero point calibration of the yaw rate and acceleration sensor and test mode inspection.

HINT:
(Click here)



1. INSPECT TIRE

HINT:
(Click here)



2. MEASURE VEHICLE HEIGHT

NOTICE:
Before inspecting the wheel alignment, adjust the vehicle height to the specified valve.



3. INSPECT TOE-IN


    SA03213E12
  1. Inspect the toe-in.

    Toe-in:
    FF 
    Tire size
    Toe-in
    (total)
    215/65R 16
    A + B: 16.2' +/- 16.2' (0.27° +/- 0.27°)
    C - D: 3.2 +/- 3.2 mm (0.13 +/- 0.13 in.)
    225/60R 17
    A + B: 16.2' +/- 16.2' (0.27° +/- 0.27°)
    C - D: 3.3 +/- 3.3 mm (0.13 +/- 0.13 in.)

    4WD 
    Tire size
    Toe-in
    (total)
    225/60R 17
    A + B: 12.6' +/- 16.2' (0.21° +/- 0.27°)
    C - D: 2.6 +/- 3.3 mm (0.10 +/- 0.13 in.)

    HINT:
    If the toe-in is not within the specified value, inspect the suspension parts and replace them if necessary.



4. INSPECT CAMBER
  1. Install the camber-caster-kingpin gauge or position the vehicle on the wheel alignment tester.

  1. Inspect the camber.

    Camber:
    FF 
    Camber
    Right-left error
    -1°22' +/- 30' (-1.37° +/- 0.5°)
    30' (0.5°) or less
    4WD 
    Camber
    Right-left error
    -1°25' +/- 30' (-1.42° +/- 0.5°)
    30' (0.5°) or less

    HINT:
    If the measured value is not within the specified value, inspect the suspension parts for damage and the wear and replace them if necessary because camber is not adjustable.