Home › SUSPENSION & AXLE › SUSPENSION › FRONT SHOCK ABSORBER WITH COIL SPRING

FRONT SHOCK ABSORBER WITH COIL SPRING > REMOVAL

for Preparation Click here



1. REMOVE FRONT WHEEL


2. REMOVE FRONT WIPER ARM HEAD CAP

HINT:
(Click here)



3. REMOVE FR WIPER ARM RH

HINT:
(Click here)



4. REMOVE FR WIPER ARM LH

HINT:
(Click here)



5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

HINT:
(Click here)



6. REMOVE WINDSHIELD WIPER MOTOR & LINK ASSEMBLY

HINT:
(Click here)



7. REMOVE COWL TOP PANEL SUB-ASSEMBLY OUTER FRONT

HINT:
When removing or installing the front shock absorber with coil spring RH, it is necessary to remove the cowl top panel sub-assembly outer front.

  1. Disconnect the wire harness from the cowl top panel sub-assembly outer front.



    F049306E01
  1. Remove the 9 bolts, cowl top brace and cowl top panel sub-assembly outer front.



8. REMOVE FRONT STABILIZER LINK ASSEMBLY LH


    F045196
  1. Remove the nut and disconnect the front stabilizer link assembly LH from the shock absorber assembly front LH.

    HINT:
    If the ball joint turns together with the nut, use a hexagon (6 mm) wrench to hold the stud.



9. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING


    F044629
  1. Loosen the lock nut.

    NOTICE:
    1. Do not loosen the nut except for the purpose of disassembling the shock absorber assembly front LH with coil spring.
    2. Do not remove the lock nut.



    C065925
  1. Remove the bolt, and disconnect the front flexible hose No.1 and speed sensor front LH.



    F013683
  1. Remove the 2 nuts and 2 bolts on the lower side of the front shock absorber with coil spring.

    NOTICE:
    When removing the bolt, hold the nut not to rotate.



    F044630
  1. Remove the 3 nuts on the upper side of the front shock absorber with coil spring.

  1. Remove the front shock absorber with the coil spring.