Home › SUSPENSION & AXLE › SUSPENSION › FRONT STABILIZER BAR (for 2WD)

FRONT STABILIZER BAR (for 2WD) > INSPECTION

for Preparation Click here



1. INSPECT FRONT STABILIZER LINK ASSEMBLY LH


    C066721
  1. As shown in the illustration, flip the ball joint stud back and forth 5 times, before installing the nut.

  1. Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per 1 turn and take the torque reading on the 5th turn.

    Turning torque:
    0.05 to 1.96 N*m (0.5 to 20kgf*cm, 0.4 to 17.4 in.*lbf)