Home › BODY › ENGINE HOOD / DOOR › POWER BACK DOOR OPENER / CLOSER SWITCH

POWER BACK DOOR OPENER / CLOSER SWITCH > INSPECTION

for Preparation Click here



1. INSPECT SATELLITE SWITCH


    B068912E01
  1. Inspect the resistance of the back door switch.

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    3 - 5
    Free (OFF)
    10 kΩ or higher
    Pushed (ON)
    Below 1 Ω

    If the result is not as specified, replace the switch.

  1. Apply battery voltage and check whether the switch illuminates.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 8
    Battery negative (-) → Terminal 7
    Illuminates

    HINT:
    Whether the switch illuminates or not will not affect the function of the RH side.
    If the result is not as specified, replace the bulb.



2. INSPECT SATELLITE SWITCH


    B068442E02
  1. Inspect the resistance of the switch for the LH / RH door.

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    1 - 5 (LH)
    4 - 5 (RH)
    Free (OFF)
    10 kΩ or higher
    Pushed (ON)
    Below 1 Ω

    If the result is not as specified, replace the switch.

  1. Apply battery voltage and check whether the switch illuminates.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 8
    Battery negative (-) → Terminal 7
    Illuminates

    HINT:
    Whether the switch illuminates or not will not affect the function of the RH side.
    If the result is not as specified, replace the bulb.