POWER BACK DOOR > ADJUSTMENT |
| 1. INSPECT BACK DOOR PANEL SUB-ASSEMBLY |
Check that the clearance is within the standard range.

| A | B | C | D |
| 106. +- 1.5 mm (0.417 +- 0.059 in.) | 7.0 +- 1.5 mm (0.276 +- 0.059 in.) | 6.0 +- 1.5 mm (0.236 +- 0.059 in.) | 5.7 +- 1.5 mm (0.224 +- 0.059 in.) |
| 2. ADJUST BACK DOOR PANEL SUB-ASSEMBLY |
![]() |
Adjust the door forward / rearward and vertically by loosening the body side hinge nuts and bolt.
Tighten the body side hinge nuts and bolt after the adjustment.
![]() |
Horizontally and vertically adjust the door by loosening the door side hinge bolts.
Tighten the body side hinge bolts after the adjustment.
Using a screwdriver, remove the back door scuff plate.
![]() |
Adjust the striker position by slightly loosening the striker mounting screws and hitting the striker with a plastic-faced hammer.
Tighten the striker mounting screws after the adjustment.