Home › BODY › ENGINE HOOD / DOOR › SLIDE DOOR CLOSER SYSTEM

SLIDE DOOR CLOSER SYSTEM > Slide Door Closer LH does not Operate

for Preparation Click here


DESCRIPTION

The slide door ECU LH controls the slide door closer. In response to the output signals from the switches in the slide door lock, the slide door closer drives the closer motor.

HINT:
The slide door closer system operates regardless of the power slide door main switch ON / OFF.


WIRING DIAGRAM


B068889E03


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-B)
  1. Inspect the ECU-B fuse.



NG
REPLACE FUSE
OK


2.INSPECT SLIDE DOOR LOCK
  1. Check that the slide door fully closes (fully locked) when the door is closed by hand.



NG
IMPROPER FIT OF SLIDE DOOR, OR A FOREIGN OBJECT IS STUCK IN SLIDE DOOR
OK


3.POWER SOURCE RESET
  1. Disconnect the ECU-B fuse and reconnect it. 10 seconds later, check that the slide door closer is operational.



OK
NORMAL
NG


4.INSPECT POWER SLIDE DOOR LOCK ASSEMBLY


    B068914E01
  1. Apply battery voltage to the terminals and check the motor operation.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 1
    Battery negative (-) → Terminal 4
    Clockwise Rotation
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 1
    Counterclockwise Rotation



    B068882E01
  1. At each range of the latch, inspect the resistance of the pawl switch and latch switch.

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    5 - 6
    Half-latch ON range
    Below 1 Ω
    3 - 5
    Full-latch ON range
    5 - 6
    3 - 5
    Over-stroke range
    More than 10 kΩ



    B068881E01
  1. Inspect the resistance of the original position switch and handle switch.

    Resistance:

    Terminal No.
    Original Position
    Switch Handle Switch
    Specified Condition
    5 - 8
    OFF (Active lever in original position)
    ON (Handle in original position)
    10 kΩ or higher
    OFF (Handle operated)
    ON (Closer in operation)
    ON (Handle in original position)
    Below 1 Ω
    OFF (Handle operated)
    10 kΩ or higher



NG
REPLACE POWER SLIDE DOOR LOCK ASSEMBLY
OK


5.CHECK WIRE HARNESS (POWER SLIDE DOOR LOCK ASSEMBLY - POWER SLIDE DOOR ECU LH)


    B068439E01
  1. Disconnect the P29 door lock and P25 ECU connectors.

  1. Check the resistance between the wire harness connectors.

    Resistance (Check for open circuit):
    Terminal No.
    Specified Condition
    P29-1 - P25-12 (DC+)
    Below 1 Ω
    P29-4 - P25-11 (DC-)
    P29-6 - P25-7 (HAF)
    P29-3 - P25-8 (FUL)
    P29-7 - P25-20 (POL)
    P29-8 - P25-21 (POS)

  1. Check the resistance between the P29 lock connector and body ground.

    Resistance (Check for open circuit):
    Terminal No.
    Specified Condition
    P29-5 - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS AND CONNECTOR
OK

REPLACE POWER SLIDE DOOR ECU LH