Home › BODY › ENGINE HOOD / DOOR › POWER SLIDE DOOR CONTROL SWITCH

POWER SLIDE DOOR CONTROL SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER SLIDE DOOR CONTROL SWITCH


    B069865E01
  1. Inspect the resistance of the switch for LH / RH.

    Resistance:
    Terminal No.
    Condition
    Specified Condition
    1 - 5
    Free (OFF)
    10 kΩ or higher
    Pushed (ON)
    Below 1 Ω

    If the result is not as specified, replace the switch.

  1. Apply battery voltage and check the illuminates.

    Standard:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 4
    Battery negative (-) → Terminal 2
    Illuminates

    If the result is not as specified, replace the bulb.

    HINT:
    Whether the switch illuminates or not will not affect the function of the LH side.