Home › STEERING › POWER STEERING › RACK AND PINION POWER STEERING GEAR

RACK AND PINION POWER STEERING GEAR > INSPECTION

for Preparation Click here



1. INSPECT POWER STEERING RACK


    ZX09355
  1. Using a dial indicator, check the power steering rack for runout and for teeth wear and damage.

    Maximum runout:
    0.3 mm (0.012 in.)

    If necessary, replace the rack & pinion power steering gear assembly.

  1. Check the back surface for wear and damage.
    If necessary, replace the rack & pinion power steering gear assembly.



2. INSPECT TIE ROD ASSEMBLY LH


    ZK08184
  1. Secure the tie rod assembly in a vise.

  1. Install the nut to the stud bolt.

  1. Flip the ball joint stud back and forth 5 times.

  1. Using a torque wrench, turn the nut continuously at a rate of 3 to 5 seconds per turn and take the torque reading on the 5th turn.

    Torque:
    Turning torque:
    0.83 to 3.43 N*m{ 8.5 to 35.0 kgf*cm , 7.3 to 30.4 in.*lbf }



3. INSPECT TIE ROD ASSEMBLY RH

HINT:
Perform the same procedure on the other side.