Home › STEERING › POWER STEERING › RACK AND PINION POWER STEERING GEAR

RACK AND PINION POWER STEERING GEAR > REMOVAL

for Preparation Click here


NOTICE:
When installing, coat the parts indicated by the arrows with power steering fluid or molybdenum disulfide lithium base grease (Click here).



1. INSPECT CENTER FRONT WHEEL


2. REMOVE FRONT WHEEL


3. SEPARATE TIE ROD ASSEMBLY LH
SST
09628-62011  


4. SEPARATE TIE ROD ASSEMBLY RH
SST
09628-62011  

HINT:
Perform the same procedure on the other side.



5. SEPARATE STEERING INTERMEDIATE SHAFT ASSEMBLY


    D030613
  1. Fix the steering wheel with the seat belt.



    D030704E03
  1. Release the 3 springs and separate the dust cover.



    D029986E03
  1. Place matchmarks on the intermediate shaft assembly and power steering gear assembly.

  1. Remove the bolt and separate the intermediate shaft assembly.



6. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH


7. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
Perform the same procedure on the other side.



8. REMOVE FRONT STABILIZER BRACKET NO.1 LH


    D030615E05
  1. Remove the 2 bolts and remove the stabilizer bracket No. 1.



9. REMOVE FRONT STABILIZER BRACKET NO.1 RH

HINT:
Perform the same procedure on the other side.



10. DISCONNECT PRESSURE FEED TUBE ASSEMBLY


    D029970
  1. Remove the clip and disconnect the return tube assembly from the power steering gear assembly.



    D029971E01
  1. Using SST, disconnect the pressure feed tube assembly from the power steering gear assembly.

    SST
    09023-12701  



    D029974
  1. Remove the bolt and separate the tube clamp.



    D029975
  1. Remove the nut and separate the tube clamp.



11. REMOVE RACK & PINION POWER STEERING GEAR ASSEMBLY


    D029979
  1. Remove the 2 bolts, nuts and the power steering gear assembly.

    NOTICE:
    Do not damage the 2 pressure tubes.