Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit of the television camera assembly.

WIRING DIAGRAM


E121277E03


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA ASSEMBLY)
  1. Disconnect the R10 connector from the navigation receiver assembly.



  1. Disconnect the T10 connector from the television camera assembly.


    E121278E06

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:

    Tester connection (Terminal No.)
    Condition
    Specified condition
    CB+ (T10-4) - CA+ (R10-24)
    Always
    Below 1 Ω
    CGND (T10-3) - CGND (R10-21)
    Always
    Below 1 Ω
    CV+ (T10-2) - V+ (R10-22)
    Always
    Below 1 Ω
    CV- (T10-1) - V- (R10-23)
    Always
    Below 1 Ω
    CB+ (T10-4) - Body ground
    Always
    10 kΩ or higher
    CGND (T10-3) - Body ground
    Always
    10 kΩ or higher
    CV+ (T10-2) - Body ground
    Always
    10 kΩ or higher
    CV- (T10-1) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.INSPECT NAVIGATION RECEIVER ASSEMBLY


  1. Reconnect the navigation receiver assembly R10 connector.


    E121279E05

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:

    Tester connection
    Condition
    Specified condition
    CB+ (T10-4) - CGND (T10-3)
    Ignition switch ON
    Shift lever R position
    Approx. 6 V



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK


3.INSPECT TELEVISION CAMERA ASSEMBLY


  1. Reconnect the navigation receiver assembly R10 connector and the television camera assembly T10 connector.


    E121280E04



    E119731E02
  1. Check the waveform of the television camera assembly using an oscilloscope.

    1. Measurement terminal: CV+ - CV-
      Measurement setting: 0.2 V/DIV, 0.2 μs/DIV
      Condition: Ignition switch ON, Shift lever in R range

      OK:
      Pulses as shown in the illustration.



NG
REPLACE TELEVISION CAMERA ASSEMBLY
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE