Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function)

REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function) > Power Source Circuit

for Preparation Click here


DESCRIPTION

Power is supplied to the fold seat control ECU through the L-RR2 SEAT and R-RR2 SEAT fuses.

WIRING DIAGRAM


B129639E03


INSPECTION PROCEDURE

1.INSPECT FUSE (L-RR2 SEAT, R-RR2 SEAT)


    B129652E02
  1. Remove the fuses from the R/B No. 3.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Item
    Condition
    Specified Condition
    L-RR2 SEAT
    Always
    Below 1 Ω
    R-RR2 SEAT
    Always
    Below 1 Ω



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (POWER SOURCE)
  1. Remove the fold seat control ECU.



    B129651E11
  1. Disconnect the connectors from the fold seat control ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH side:
    Terminal No.
    (Symbols)
    Condition
    Specified Condition
    P62-3 (IG) - Body ground
    Ignition switch: OFF
    Below 1 V
    P62-3 (IG) - Body ground
    Ignition switch: ON
    10 to 14 V
    P63-4 (+B) - Body ground
    Always
    10 to 14 V
    RH side:
    Terminal No.
    (Symbols)
    Condition
    Specified Condition
    P64-3 (IG) - Body ground
    Ignition switch: OFF
    Below 1 V
    P64-3 (IG) - Body ground
    Ignition switch: ON
    10 to 14 V
    P65-4 (+B) - Body ground
    Always
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (GROUND)


    B129651E12
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P63-8 (GND) - Body ground
    Always
    Below 1 Ω
    RH side:
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P65-8 (GND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE