Home › BODY › SEAT › REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function)

REAR NO. 2 SEAT ASSEMBLY (w/ Power Stowing Function) > Back Door Courtesy Switch Circuit

for Preparation Click here


DESCRIPTION

The fold seat control ECU receives signals from the back door courtesy switch and detects the state of the back door (open/close). If the ECU does not detect that the back door is open, the seat stowing and return functions are not available.

WIRING DIAGRAM


B129646E02


INSPECTION PROCEDURE

1.INSPECT FOLD SEAT CONTROL ECU


    B129650E50
  1. Remove the fold seat control ECU with connectors still connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH side 
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P62-5 (BDCY) - Body ground
    Back door courtesy switch: OFF
    10 to 14 V
    P62-5 (BDCY) - Body ground
    Back door courtesy switch: ON
    Below 1 V
    RH side 
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P64-5 (BDCY) - Body ground
    Back door courtesy switch: OFF
    10 to 14 V
    P64-5 (BDCY) - Body ground
    Back door courtesy switch: ON
    Below 1 V



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2.INSPECT BACK DOOR COURTESY SWITCH


    B129656E01
  1. Disconnect the connector from the back door courtesy switch.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    B11-6 - B11-5
    Back door courtesy switch: OFF
    10 kΩ or higher
    B11-6 - B11-5
    Back door courtesy switch: ON
    Below 1 Ω



NG
REPLACE BACK DOOR COURTESY SWITCH
OK


3.CHECK HARNESS AND CONNECTOR (FOLD SEAT CONTROL ECU - BACK DOOR COURTESY SWITCH)


    B129666E02
  1. Disconnect the connectors from the fold seat control ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    LH side 
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P62-5 (BDCY) - B11-6
    Always
    Below 1 Ω
    P62-5 (BDCY) - Body ground
    Always
    10 kΩ or higher
    RH side 
    Tester Connection
    (Symbols)
    Condition
    Specified Condition
    P64-5 (BDCY) - B11-6
    Always
    Below 1 Ω
    P64-5 (BDCY) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (BACK DOOR COURTESY SWITCH - BODY GROUND)


    B129657E01
  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester connection
    (Symbols)
    Condition
    Specified condition
    B11-5 - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE FOLD SEAT CONTROL ECU